- 644 - .460(11.68) .420(10.6) .160(4.1) .140(3.6) .153(3.9) .146(3.7) .050(1.27) .5 min (12.7) spacing ac .035(0.9) .028(0.7) .600(15.24) .560(14.22) kbp301g thru kbp307g single phase 3.0 amps. glass passivated bridge rectifiers voltage range 50 to 1000 volts current 3.0 amperes features ul recognized file # e-96005 glass passivated junction ideal for printed circuit board reliable low cost construction technique results in inexpensive product high temperature soldering guaranteed: 260 / 10 seconds at 5 lbs. ( 2.3 kg ) tension small size, simple installation leads solderable per mil-std-202, method 208 kbp dimensions in inches and (millimeters) maximum ratings and electrical characteristics rating at 25 ambient temperature unless otherwise specified. single phase, half wave, 60 hz, resistive or inductive load. for capacitive load, derate current by 20% type number symbol kbp 301g kbp 302g kbp 303g kbp 304g kbp 305g kbp 306g kbp 307g units maximum recurrent peak reverse voltage v rrm 50 100 200 400 600 800 1000 v maximum rms voltage v rms 35 70 140 280 420 560 700 v maximum dc blocking voltage v dc 50 100 200 400 600 800 1000 v maximum avera g e forward rectified current @t a = 50 i (av) 3.0 a peak forward surge current, 8.3 ms single half sine-wave superimposed on rated load (jedec method ) i fsm 80 a maximum instantaneous forward voltage @ 3.0a v f 1.1 v maximum dc reverse current @ t a =25 at rated dc blocking voltage @ t a =125 i r 10 500 ua ua typical thermal resistance (note 1) r ja r jl 30 11 /w operating temperature range t j -55 to +150 storage temperature range t stg -55 to +150 note 1. thermal resistance from junction to ambient and from junction to lead mounted on pcb with 0.4? x 0.4? (10mm x 10mm) copper pads.
- 645 - ratings and characteristic curves (kbp301g thru kbp307g) fig.4- typical reverse characteristics per bridge element instantaneous reverse current .( a) 0 20 40 60 80 100 120 140 0.1 1 10 100 percent of rated peak reverse voltage. (%) tj=125 c 0 tj=25 c 0 fig.1- maximum non-repetitive forward surge current per bridge element peak for ward surge current . (a) 10 246 1 40 60 20 100 30 20 40 50 70 80 60 number of cycles at 60hz fig.2- maximum forward current derating curve average for ward current . (a) 20 40 60 80 100 120 140 150 0 4.0 3.0 2.0 1.0 ambient temperature. ( c) o fig.3- typical instantaneous forward characteristics per bridge element instantaneous for ward current . (a) .6 .7 .9 .8 1.0 1.3 1.1 1.2 1.4 .01 0.1 1.0 10.0 instantaneous forward voltage. (v) tj=25 c pulse width-300 s 1% duty cycle 0
|
